Chapter 4 Notes On Solaris Os Operation; Enter The Openboot Environment; Cd-Rom/Dvd-Rom In Unix File System (Ufs) Format; Ttya Port Of Sparc Enterprise T1000/T2000/T5120/T5140/T5220/T5240 Servers - Fujitsu B23Q8WD-G-01-J Hardware Manual

Sparc enterprise servers for solaris operating system
Table of Contents

Advertisement

Chapter 4 Notes on Solaris OS operation

This chapter describes notes on Solaris OS operation.
4.1

Enter the OpenBoot environment

If a running system is moved to Open Boot Environment forcibly, data of the system might be damaged.
To suppress an accidental break signal, do the following.
SPARC Enterprise T1000/T2000/T5120/T5140/T5220/T5240 servers
1.
KEYBOARD_ABORT=disable
2.
# kbd –i <Return>
SPARC Enterprise SPARC Enterprise M3000/M4000/M5000/M8000/M9000 servers
Set the mode switch on the operator panel to Locked and enable Secure Mode on each domain. For how to
enable Secure Mode, refer to setdomainmode(8) in the "SPARC Enterprise
M3000/M4000/M5000/M8000/M9000 servers XSCF Reference Manual".
4.2

CD-ROM/DVD-ROM in UNIX file system (UFS) format

Do not use any CD-ROM/DVD-ROM in UNIX file system (UFS) format that is not produced for the Solaris
OS.
Even if the file system in such a CD-ROM/DVD-ROM is in UFS format, its file construction may differ
from that of a Solaris system. If such a CD-ROM/DVD-ROM is used, serious problems, including a system
crash may occur.
4.3
TTYA port of SPARC Enterprise
T1000/T2000/T5120/T5140/T5220/T5240 servers
TTYA port is used only for standard serial device. Console of the Solaris OS is not supported via TTYA.
Do not set "ttya" as the value of OpenBoot PROM environment variables, "input-device" and
"output-device".
For more information, refer to "SPARC Enterprise T1000 Server Administration Guide", "SPARC
Enterprise T2000 Server Administration Guide", "SPARC Enterprise T5120 and T5220 servers
Administration Guide" or "SPARC Enterprise T5140 and T5240 servers Administration Guide."
4.4

The order of instance numbers of optional cards

If an additional option card is installed, the instance number on the card might be assigned out of order.
Additional installation by Dynamic Reconfiguration or PCI Hot-plug is also applicable but replacement by
Dynamic Reconfiguration or PCI Hot plug is not applicable.
Edit the /etc/default/kbd as follows:
Set keyboard defaults from the /etc/default/kbd file.
9

Advertisement

Table of Contents
loading

Table of Contents