Display System Components - Fujitsu SPARC ENTERPRISE T5140 Service Manual

●
At the -> prompt, enter the show components command.
In the following example, PCIE3 is shown as disabled.
-> show components
Target
--------------------+------------------------+-------------------------------
/SYS/MB/RISER0/
PCIE0
/SYS/MB/RISER0/
PCIE3
/SYS/MB/RISER1/
PCIE1
/SYS/MB/RISER1/
PCIE4
/SYS/MB/RISER2/
PCIE2
/SYS/MB/RISER2/
PCIE5
/SYS/MB/NET0
/SYS/MB/NET1
/SYS/MB/NET2
/SYS/MB/NET3
/SYS/MB/PCIE
Related Information
"Display System Components" on page 51
■
"Disable System Components" on page 52
■
"Enable System Components" on page 53
■
▼ Disable System Components
You disable a component by setting its component_state property to Disabled.
This adds the component to the ASR blacklist.
1. At the -> prompt, set the component_state property to Disabled.
-> set /SYS/MB/CMP0/BR1/CH0/D0 component_state=Disabled
2. Reset the server so that the ASR command takes effect.
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
| Property
| component_state
|
| component_state
|
| component_state
|
| component_state
|
| component_state
|
| component_state
|
| component_state
| component_state
| component_state
| component_state
| component_state
| Value
| Enabled
|
| Disabled
|
| Enabled
|
| Enabled
|
| Enabled
|
| Enabled
|
| Enabled
| Enabled
| Enabled
| Enabled
| Enabled
Detecting and Managing Faults 51