Post Output Quick Reference - Fujitsu SPARC ENTERPRISE T5140 Service Manual

2. Clear the fault by setting the FRU's component_state property to Enabled.
This will remove the component from the ASR blacklist.
Use the FRU name that was reported in the fault in
-> set /SYS/MB/CMP0/BR1/CH0/D0 component_state=Enabled
The fault is cleared and should not show up when you run the show faulty
command. Additionally, the Service Required LED is no longer on.
3. Reset the server.
You must reboot the server for the change to the component_state property to
take effect.
4. At the ILOM prompt, use the show faulty command to verify that no faults
are reported.
-> show faulty
Target
--------------------+------------------------+------------------
->

POST Output Quick Reference

POST error messages use the following syntax:
c:s > ERROR: TEST = failing-test
c:s > H/W under test = FRU
c:s > Repair Instructions: Replace items in order listed by H/W
under test above
c:s > MSG = test-error-message
c:s > END_ERROR
In this syntax, c = the core number, s = the strand number.
Warning messages use the following syntax:
WARNING: message
Informational messages use the following syntax:
INFO: message
42 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
| Property
Step 1:
| Value