a. All FB-DIMMs removed from the previous motherboard. Ensure that the
FB-DIMM modules are installed in the same memory configuration as they
were in before.
See
"FB-DIMM Configuration Guidelines for SPARC Enterprise T5140 Servers"
on page 94
or
"FB-DIMM Configuration Guidelines for SPARC Enterprise
T5240 Servers" on page 98
b. SCC module. See
6. Connect the hard drive data cables. For cable routing instructions, see
whichever of the following topics apply:
"Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5140
■
Servers" on page 190
"Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5240
■
Servers" on page 204
7. Install the air duct.
See
"Install the Air Duct" on page
8. Reinstall the motherboard-to-power distribution board ribbon cable.
9. Reinstall the PCIe and XUAI risers.
See
"Install a PCIe/XAUI Riser" on page
10. Install the top cover.
See
"Install the Top Cover" on page
11. Install the server into the rack.
See
"Reinstall the Server in the Rack" on page
12. Attach the power cables.
See
"Connect Power Cords to the Server" on page
13. Power on the server.
See
"Power On the Server Using the poweron Command" on page 181
On the Server Using the Front Panel Power Button" on page
Related Information
"Remove the Motherboard Assembly" on page 123
■
for guidance.
"Install the SCC Module" on page
104.
107.
177.
117.
178.
181.
182.
Servicing Motherboard Components
or
"Power
127