Numerical Setting-Rotate; Center - Brother PEDESIGN 5.0 Instruction Manual

NOTE:
The maximum value that can be entered is the largest value that will not allow the pattern to
exceed the size of the Design Page.
The minimum value is 1 mm (0.04 inch).
See also:
I

Numerical Setting-Rotate

Purpose:
Shortcut key:
Toolbar:
Operation:
1
Select one or more patterns.
2
Click , then
Edit Numerical Setting
The dialog appears.
Rotate
NOTE:
The range of values that can be entered is between 0 and 359 degrees, in 1degree increments.
I

Center

Purpose:
Shortcut key:
Toolbar:
Operation:
1
Select one or more objects.
2
Click , then
Edit Center
The entire selected object moves to the center of Design Page.
NOTE:
For Letters Fit to a Path
If you select either the letters or the path only, the selected object will be moved to the center of
Design page, but the unselected object will not be moved with it.
For Objects set for Hole Sewing
When selecting an object set as part of a hole sewing pattern, the selected object will be
moved to the center of Design Page, but the unselected objects will not be moved with it.
172
"Select System Unit" on page 229
Rotates the selected pattern numerically.
No shortcut key for this function
No button for this function
, then
Moves the selected object to the center of Design Page.
+
Ctrl M
No button for this function
.
.
Rotate
N The desired rotation angle can be entered
by either typing in a value or clicking the
arrows to select the desired value.
Select
0 degree
unchanged.
N Click
OK
N Click
Preview
the specified angle in the Design Page.
N Click
Cancel
changes.
to leave the pattern
to confirm.
to view the pattern rotated
to exit without making any