Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 91

Chapter 4 Troubleshooting the CTS 500
Figure 4-12 Setting Up Focus Targets and Aligning Horizontal Bars
Large
target
Small
target
Red and green
horizontal bars
Step 5 Loosen the thumbscrew on the lens focus ring.
Step 6 Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen are
reduced to very short lengths on the left.
Step 7 Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
Step 8 Continue to twist the focus ring until the red and green bars are approximately the same length. See
Figure 4-12
length, the camera is focused.
The red and green bars do not have to be exactly the same length. Get them as close as you can.
Note
Without moving the focus ring, tighten its thumbscrew.
Step 9
Step 10 Click Done.
Step 11 Click Stop to stop the test.
OL-21845-01
to view the approximate horizontal bar alignment. When the bars are roughly the same
Managing CTS 500 Hardware Setup
Red
rectangle
Green
rectangle
Cisco TelePresence System Administration Guide
4-19