Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 178

Managing CTS 1100 Hardware Setup
Figure 7-4
Camera
rotation
screw
Place the small
Step 3
adjust screws. Use a 3mm Allen wrench for these screws.
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target:
Remove the easel, large camera target, and small camera target from their packaging.
Step 1
Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 2
Separate the three legs.
Step 3
Raise the front legs until they are 29 inches (74 cm) high.
Step 4
Raise the rear leg until it is 31 inches (79 cm) high.
Step 5
Lock the legs into place using the leg locks.
Step 6
Step 7 Attach the large camera target to the clip on top of the easel.
Step 8 Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9 Raise and lower the front legs until the bottom of the camera target is 32 inches (81 cm) above the
ground.
Cisco TelePresence System Administrator Guide
7-8
Leveling the Camera Assembly
Camera
Level
rotation
screw
spirit level on the camera and make sure that it is level. Use the rotational (side-to-side)
Chapter 7 Troubleshooting the CTS 1100
OL-21845-01