Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 18

For all SCCP and SIP firmware upgrades from firmware release versions earlier than 8.3(3) to version
Note
8.5(3) or a later release, you must first upgrade your firmware to version 8.5(2). Once you have upgraded
to version 8.5(2), you can upgrade your Cisco Unified IP Phone to version 8.5(3) or a later release.

See the
8.5(3) (SCCP and SIP)
Configure the Cisco Unified IP phone as follows:
1.
2.
MAC Address
Make sure the MAC address of the device you are installing is known or available:
•
•
Note
Laptop Screen Resolution
For best results, Cisco recommends that you change the screen resolution to 1024 x 768.
Document Organization
Information about using the Cisco TelePresence System Administration interface is provided in the
following chapters:
•
•
•
•
•
•
Cisco TelePresence System Administration Guide
iv
Installation Notes section of the
for download instructions.
If option 150 of DHCP is enabled—Alternative TFTP=NO
If you use manual entry—Alternative TFTP=YES
For more information about the Cisco Unified IP Phone 7970/7975 series, refer to the
Cisco Unified IP Phones 7900 Series Maintain and Operate Guides
http://www.cisco.com/en/US/products/hw/phones/ps379/prod_maintenance_guides_list.html
The MAC address comprises a unique 12-character hexadecimal number that identifies a
Cisco Unified IP phone or other hardware device.
Locate the MAC address number on a label on the back of the Cisco TelePresence system primary
codec (for example, 000B6A409C405). Cisco Unified CM makes the MAC address a required field
for Cisco Unified IP phone device configuration.
The MAC address is also displayed on the CTS main display screen during boot-up.
When entering the MAC address in Cisco Unified CM fields, do not use spaces or dashes, and
do not include any other characters that may precede the MAC address on the label.
Chapter 1, "Using the Cisco TelePresence System Administration Interface"
Chapter 2, "Device Information"
Chapter 3, "Configuring the Cisco TelePresence System"
Chapter 4, "Troubleshooting the CTS 500"
Chapter 5, "Troubleshooting the CTS 500 32""
Chapter 6, "Troubleshooting the CTS 1000"
Cisco Unified IP Phone Release Notes for Firmware Release
What's in This Guide
page at the following URL:
OL-21845-01