Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 49

Chapter 3 Configuring the Cisco TelePresence System
Figure 3-3
Determine the IP address that the Cisco TelePresence system provided for your session.
Step 2
For Windows-based systems, you can see the IP address in the Support tab in the Local Area Connection
Tip
Status window.
Step 3 Using Secure Shell SSH or another secure client program, start a CLI session with the
Cisco TelePresence system using the IP address xxx.xxx.xxx.1, 

Where:
xxx.xxx.xxx is the IP address that Cisco TelePresence provided for your session. 

For example, if your determine that the Cisco Telepresence system provided an IP address of 10.1.0.2,
enter the address 10.1.0.1.

By default, the username is admin and the password is cisco.
Network services are started automatically. If needed, enter the following command to start network
Step 4
services:
utils service start Calling_Services
Using a supported Internet browser, log in to the Cisco TelePresence system GUI with the IP address
Step 5
that you used in
Enter the username and password when prompted. By default, the user is admin and the password is
Step 6
cisco.
Step 7 Navigate to Configuration > IP Settings.
Change the DHCP Enabled setting to No.
Step 8
Enter a static IP address, subnet mask, and IP gateway for your system into the fields. Optionally, enter
Step 9
DNS server(s) and the network domain name. Your system saves the changes and automatically restarts.
OL-21845-01
Auxiliary Network Port Location
Step 3.
First Time Setup for All Other CTS Models
Cisco TelePresence System Administration Guide
3-5