Chapter 9
Troubleshooting the CTS 3000 and CTS 3200
On both sides of the display, you will see two small red hash marks. Adjust the camera so that the
edge of the table is positioned vertically exactly between the hash marks on either side of the display.
See
Note
Figure 9-3
OL-21845-01
Figure 9-3
for the location of the adjustment screws on the camera.
If one of the left/right screws is covered by the camera cable, do not disturb the cable but instead
use the other screw to make all left/right adjustments.
Camera Mounting Plate
Managing CTS 3000 and CTS 3200 Hardware Setup
Left/right screws
Rotation screws
Lens
Up/down screw
Cisco TelePresence System Administration Guide
9-9