Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 227

Chapter 8 Troubleshooting the CTS 1300
Figure 8-10
Step 3 Make sure that the camera assembly is level by completing the steps in the
and Leveling the Cameras" section on page
Step 4 Build the easel, and attach the large camera target to the easel, by completing the steps in the
the Large Camera Target to the Easel" section on page
32 inches above the ground.
Step 5 Log in to the Cisco TelePresence System Administration interface.
Step 6 Select the table type by completing the following steps:
a. Choose Troubleshooting > Hardware Setup.
b. Click the Configuration radio button. The table configuration window appears, as shown in
Figure
Click the Start button to start testing.
c.
Select the type of table you have from the drop-down menu:
d.
–
–
–
OL-21845-01
Long Racetrack Table Positioning
A
10 feet
44 inches
minimum
30 inches
8-2.
Long Straight Table (Figure
Long Racetrack Table (Figure
Short Straight Table (Figure
A=B
B
6 feet minimum,
12 feet maximum,
8 feet recommended
8-8.
8-11, making sure that the bottom of the target is
8-11)
8-12)
8-13)
Cisco TelePresence System Administration Guide
Managing CTS 1300 Hardware Setup
"Removing the Camera Cover
"Attaching
8-15