Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 347

Chapter 10 Troubleshooting the CTS 3010 and CTS 3210
Figure 10-8
Step 3 In the Cisco TelePresence Administration interface, click Setup, then click Show Focus Target.
Step 4 Adjust the small target so that the red box encloses the upper patterns on the large target and the green
box encloses the patterns on the small target.
Figure 10-9 Positioning the Small and Large Targets
Large
target
Small
target
Red and green
horizontal bars
Step 5 Adjust the focus on the camera by performing the following steps:
a.
OL-21845-01
Arranging the Small and Large Targets
Large target
Loosen the thumbscrew for the lens focus ring. The ring is labeled "N-8".
5 ft
Small target
Cisco TelePresence System Administration Guide
Managing CTS 3010 and CTS 3210 Hardware Setup
10 ft
Red
rectangle
Green
rectangle
10-13