Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 236

Managing CTS 1300 Hardware Setup
Figure 8-20 Adjusting the Camera Zoom
Note curved
lines touching
screen border
Tighten the thumbscrews for the zoom and focus rings.
Step 10
Click Hide Camera Targets to remove the alignment images.
Step 11
Click the Setup button, then click the Auto Adjust button. The auto adjust procedure completes. This
Step 12
procedure takes several seconds.
If there is sufficient light for the system to operate, the gain will be greater than 1 and less than 7 and
Note
the process completes normally. If there is insufficient light, the auto adjust procedure terminates. In this
case, add more light to the room to bring the gain value below 7. Then repeat the auto adjust procedure.
Step 13 Click Done.
Step 14 To determine the edge of the target when you calibrate and configure the left and right cameras, mark
the edges of the large camera target on the table with tape or a marker.
Calibrating the Right Camera
To adjust the zoom and focus the right camera.
The directions left and right refer to the assembly as you face the display.
Note
Slide the large camera target to the right five feet so that the left edge of the target is lined up with the
Step 1
tape marker that you placed on the table in the
Cisco TelePresence System Administration Guide
8-24
Chapter 8
"Calibrating the Center Camera" section on page
Troubleshooting the CTS 1300
Red plus
sign within
black cross
8-20.
OL-21845-01