Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 84

Managing CTS 500 Hardware Setup
Tip If you have a pedestal stand-mounted CTS 500 and applied the height sticker, you can use it to choose
an approximate height. For more information about the height sticker, see the
Stand-Mounted CTS 500"
Field Replaceable Unit
Position the easel so the black plus sign (+) of the target is in the same position as the red plus sign 
Step 9
(+) on the display.
Adjust the camera so that the red
Step 10
aligned to the top of the table.
Tip You can raise and lower the large target by adjusting the legs of the easel or move the target slightly from
side to side. However, do not move the easel from the position that the user will occupy. If possible, move
the camera to accommodate the position of the easel.
Figure 4-8
Figure 4-8 Camera Adjustment
Note curved
lines touching
screen border
Loosen the thumbscrew on the camera and twist the zoom ring on the lens until the curved lines on the
Step 11
left and right are just touching the left and right borders of the screen. Make sure the black plus sign 
(+) is still in the same position as the red plus sign (+). Tighten the thumbscrew when the adjustment is
complete.
See
Step 12 Click Remove Camera Target to stop the test.
Cisco TelePresence System Administration Guide
4-12
chapter in the
Guide.
shows a camera correctly adjusted.
Figure 4-8 for an example of correct zoom adjustment.
Cisco TelePresence System 500 Assembly, Use & Care, and
+ is centered on the white target and the hash marks at each side are
Chapter 4 Troubleshooting the CTS 500
"Assembling a Pedestal
Green
rectangle
Red plus
sign within
black cross
OL-21845-01