Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 235

Chapter 8 Troubleshooting the CTS 1300
Figure 8-19
Side to side
adjust screw
Adjust the camera zoom by completing the following steps:
Step 9
a. Loosen the thumbscrew for the zoom ring on the camera lens.
Note
b. Adjust the camera zoom so that the black curved lines on each side of the target touch the edge of
the display screen, as shown in
c. After you adjust the zoom, make any required adjustments to the focus with the focus ring.
OL-21845-01
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T."
Up/down
adjust
screw
Figure 8-20.
Cisco TelePresence System Administration Guide
Managing CTS 1300 Hardware Setup
Right
adjust
screw
Side to side
adjust screw
8-23