Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual page 225
Telepresence system
Hide thumbs
Also See for CTS 1000 - TelePresence System 1000 Video Conferencing:
- Hardware options & upgrade manual (142 pages)
Table of Contents
Advertisement
Chapter 8
Troubleshooting the CTS 1300
If four or more of the six participants directly face the display, follow the procedure in the
the CTS 1300 for Use With a Long Straight Table, Wide Rectangular Table, or Long Racetrack table"
section on page 8-13
Configuring the CTS 1300 for Use With a Long Straight Table, Wide Rectangular Table, or Long Racetrack table
Note
If you log out of the Cisco TelePresence System Administration interface at any time during the camera
testing procedure, you must re-select the table type. To select the correct table type, complete the steps
in the
This section includes the procedures you perform to configure the CTS 1300 software and cameras for
use with a room that has a long straight table, wide rectangular table, or wide racetrack table, and
includes the following topics:
•
•
•
•
•
•
•
Positioning the Table and Starting the Calibration Procedure
To correctly position the table and configure the Cisco TelePresence software for use with the CTS 1300
cameras:
Step 1
Position the table so that there is a minimum of 44 inches between the display and the front of the table,
and make sure that the sides of the table are evenly positioned on each side of the CTS 1300, as shown
in the following examples:
•
•
•
Step 2
Make sure that the farthest edge of the table is no farther than 110 inches away from the lower bezel of
the display.
Note
The table must be 28 to 32 inches high. 30 inches is the optimal height.
OL-21845-01
"Positioning the Table and Starting the Calibration Procedure" section on page
Positioning the Table and Starting the Calibration Procedure, page 8-13
Calibrating the Center Camera, page 8-20
Calibrating the Right Camera, page 8-24
Calibrating the Left Camera, page 8-26
Focusing the Center Camera, page 8-28
Focusing the Right Camera, page 8-30
Focusing the Left Camera, page 8-30
Long, straight table,
Figure 8-8
Wide rectangular table,
Figure 8-9
Long racetrack table,
Figure 8-10
Managing CTS 1300 Hardware Setup
Cisco TelePresence System Administration Guide
"Configuring
8-13.
8-13
Advertisement
Table of Contents
Troubleshooting
