Table of Contents
Advertisement
BJ7.
Corruption of CS Segment Register During RSM While Transitioning
From Real Mode to Protected Mode
Problem:
During the transition from real mode to protected mode, if an SMI (System
Management Interrupt) occurs between the MOV to CR0 that sets PE (Protection
Enable, bit 0) and the first far JMP, the subsequent RSM (Resume from System
Management Mode) may cause the lower two bits of CS segment register to be
corrupted.
Implication:
The corruption of the bottom two bits of the CS segment register will have no impact
unless software explicitly examines the CS segment register between enabling
protected mode and the first far JMP. Intel
Developer's Manual Volume 3A: System Programming Guide, Part 1, in the section
titled "Switching to Protected Mode" recommends the far JMP immediately follows the
write to CR0 to enable protected mode. Intel has not observed this erratum with any
commercially available software.
Workaround:
None identified.
Status:
For the steppings affected, see the Summary Tables of Changes.
BJ8.
Debug Exception Flags DR6.B0-B3 Flags May be Incorrect for Disabled
Breakpoints
Problem:
When a debug exception is signaled on a load that crosses cache lines with data
forwarded from a store and whose corresponding breakpoint enable flags are disabled
(DR7.G0-G3 and DR7.L0-L3), the DR6.B0-B3 flags may be incorrect.
Implication:
The debug exception DR6.B0-B3 flags may be incorrect for the load if the
corresponding breakpoint enable flag in DR7 is disabled.
Workaround:
None identified.
Status:
For the steppings affected, see the Summary Tables of Changes.
BJ9.
DR6.B0-B3 May Not Report All Breakpoints Matched When a MOV/POP
SS is Followed by a Store or an MMX Instruction
Problem:
Normally, data breakpoints matches that occur on a MOV SS, r/m or POP SS will not
cause a debug exception immediately after MOV/POP SS but will be delayed until the
instruction boundary following the next instruction is reached. After the debug
exception occurs, DR6.B0-B3 bits will contain information about data breakpoints
matched during the MOV/POP SS as well as breakpoints detected by the following
instruction. Due to this erratum, DR6.B0-B3 bits may not contain information about
data breakpoints matched during the MOV/POP SS when the following instruction is
either an MMX instruction that uses a memory addressing mode with an index or a
store instruction.
Implication:
When this erratum occurs, DR6 may not contain information about all breakpoints
matched. This erratum will not be observed under the recommended usage of the MOV
SS,r/m or POP SS instructions (i.e., following them only with an instruction that writes
(E/R)SP).
Workaround:
None identified.
Status:
For the steppings affected, see the Summary Tables of Changes.
22
®
64 and IA-32 Architectures Software
Specification Update
Hide quick links:
Advertisement
Table of Contents
