Intel BV80605001914AG - Processor - 1 x Xeon X3430 Specification page 50
Specification update
Hide thumbs
Also See for BV80605001914AG - Processor - 1 x Xeon X3430:
Table of Contents
Advertisement
Status:
For the steppings affected, see the Summary Tables of Changes.
AAO103.
Performance Monitoring Event FP_MMX_TRANS_TO_MMX May Not
Count Some Transitions
Problem:
Performance Monitor Event FP_MMX_TRANS_TO_MMX (Event CCH, Umask 01H) counts
transitions from x87 Floating Point (FP) to MMX™ instructions. Due to this erratum, if
only a small number of MMX instructions (including EMMS) are executed immediately
after the last FP instruction, a FP to MMX transition may not be counted.
Implication:
The count value for Performance Monitoring Event FP_MMX_TRANS_TO_MMX may be
lower than expected. The degree of undercounting is dependent on the occurrences of
the erratum condition while the counter is active. Intel has not observed this erratum
with any commercially available software.
Workaround:
None Identified.
Status:
For the steppings affected, see the Summary Tables of Changes.
AAO104.
INVLPG Following INVEPT or INVVPID May Fail to Flush All
Translations for a Large Page
Problem:
This erratum applies if the address of the memory operand of an INVEPT or INVVPID
instruction resides on a page larger than 4KBytes and either (1) that page includes the
low 1 MBytes of physical memory; or (2) the physical address of the memory operand
matches an MTRR that covers less than 4 MBytes. A subsequent execution of INVLPG
that targets the large page and that occurs before the next VM-entry instruction may
fail to flush all TLB entries for the page. Such entries may persist in the TLB until the
next VM-entry instruction.
Implication:
Accesses to the large page between INVLPG and the next VM-entry instruction may
incorrectly use translations that are inconsistent with the in-memory page tables.
Workaround:
None Identified.
Status:
For the steppings affected, see the Summary Tables of Changes.
AAO105.
The PECI Bus May be Tri-stated After System Reset
Problem:
During power-up, the processor may improperly assert the PECI (Platform Environment
Control Interface) pin. This condition is cleared as soon as Bus Clock starts toggling.
However, if the PECI host (also referred to as the master or originator) incorrectly
determines this asserted state as another PECI host initiating a transaction, it may
release control of the bus resulting in a permanent tri-state condition.
Implication:
Due to this erratum, the PECI host may incorrectly determine that it is not the bus
master and consequently PECI commands initiated by the PECI software layer may
receive incorrect/invalid responses.
Workaround:
To workaround this erratum the PECI host should pull the PECI bus low to initiate a
PECI transaction.
Status:
For the steppings affected, see the Summary Tables of Changes.
AAO106.
LER MSRs May Be Unreliable
Problem:
Due to certain internal processor events, updates to the LER (Last Exception Record)
MSRs, MSR_LER_FROM_LIP (1DDH) and MSR_LER_TO_LIP (1DEH), may happen when
no update was expected.
Implication:
The values of the LER MSRs may be unreliable.
Workaround:
None Identified.
50
Specification Update
Advertisement
Table of Contents
