Ats0 Set Number Of Rings Before Automatically Answering The Call - Siemens MC55 Command Set

MC55 AT Command Set
7.11 ATS0
7.11 ATS0 Set number of rings before automatically answering the
call
Syntax
Read Command
ATS0?
Response(s)
<n>
OK
Write Command
ATS0=<n>
Response(s)
OK
PIN ASC0 ASC1 MUX1
§ % %
Reference(s)
V.25ter
Command Description
This parameter setting determines the number of rings before automatic answering.
Parameter Description
(num)(&W)(&V)
<n>
(&F)
000
001-255
Notes
• This command works for MT data and fax calls.
• Autoanswering of CSD data and fax calls is supported on ASC0/Mux1 only.
• A CSD call will not be answered automatically if the module is in GPRS online mode. However, this is possible
in GPRS command mode. The application can detect a call by evaluating the RING line and distinguish to
change into GPRS command Mode or stay in GPRS Online mode until GPRS is available again. To answer,
to reject or to wait for automatic anwsering the incoming call the application has to switch into GPRS com-
mand mode.
• If is set to higher values, the calling party may terminate the call establishment before the call can be
<n>
automatically answered.
MC55_ATC_V01.05
Confidential / Released
MUX2 MUX3
% % %
automatic answering is disabled
enable automatic answering on the specified ring number
Page 153 of 469
s
m
obile
2/10/04