Table of Contents
Advertisement
MC55 AT Command Set
8.5 AT^SMONC
(num)
<LAC>
Location area code
4 digits, e.g. 3010
0000
(num)
<cell>
Cell identifier
4 hexadecimal digits, e.g. 4EAF
0000
(num)
<BSIC>
Base station identity code
2 digits, e.g. 32
00
(num)
<chann>
ARFCN (Absolute Frequency Channel Number)
0
(num)
<RSSI>
Received signal level of the BCCH carrier (0..63). The indicated value is composed of the measured value in
dBm plus an offset. This is in accordance with a formula specified in 3GPP TS 05.08
(num)
<C1>
Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter can-
not be updated. In such cases a '-' is presented.
(num)
<C2>
Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter can-
not be updated. In such cases a '-' is presented.
Note
•
To some extent, the cell monitoring commands
eters. The receiving level, for example, can be queried with all three commands. Yet the resulting values may
be slightly different, even though obtained over a time period of a few seconds. This is quite normal and noth-
ing to worry about, as the cell information is permanently updated.
MC55_ATC_V01.05
Confidential / Released
not decoded
not decoded
not decoded
not decoded. In this case, all remaining parameters related to the same chan-
nel are neither decoded. For example, a non-existing cell appears as follows:
000,000,0000,0000,00,0,0,-,-
AT^MONI
Page 196 of 469
,
and
AT^MONP
AT^SMONC
s
m
obile
cover the same param-
2/10/04
Advertisement
Table of Contents
