At^sbv Battery/Supply Voltage - Siemens MC55 Command Set

MC55 AT Command Set
17.4 AT^SBV
17.4

AT^SBV Battery/Supply Voltage

Syntax
Test Command
AT^SBV=?
Response(s)
OK
ERROR
+CME ERROR:
Exec Command
AT^SBV
Response(s)
^SBV: <value>
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 MUX1
! % %
Reference(s)
SIEMENS
Command Description
The exec command allows to monitor the supply (or battery) voltage of the module measured on pin BATT+. The
reference point for measuring the voltage are the test points BATT+ and GND on the bottom of the module. Refer
to [1] for information on the module's test points.
The displayed value is constant over the measurement period. The duration of the measurement period depends
on the operating mode on the radio interface: it ranges from 0.5s in TALK / DATA mode up to 50s when MC55
is in IDLE mode or Limited Service (deregistered).
Parameter Description
(num)
<value>
supply (or battery) voltage in mV
MC55_ATC_V01.05
Confidential / Released
MUX2 MUX3
% % %
Page 433 of 469
s
m
obile
2/10/04