Table of Contents
Advertisement
MC55 AT Command Set
3.2 AT+CIND
PIN
ASC0
ASC1
MUX1
!
%
%
Reference(s)
GSM 07.07
Command Description
The read command returns the status of the ME indicators.
The write command is used to switch the event report for each indicator type. The Indicator Event Reports are
displayed to the TE via "
+CIEV
Parameter Description
(num)
<indValue>
Integer type value, which shall be in range of corresponding
(str)
<indDescr>
String values and their
<indValue>
More indications are available via
mended.
The following indications are accessible via
"battchg"
"signal"
"service"
"sounder"
"message"
"call"
MC55_ATC_V01.05
Confidential / Released
MUX2
MUX3
%
%
%
" which can be enabled using
ranges.
. Therefore use of
AT^SIND
AT+CIND
Battery charge level 0..4 or 5 if no measuring is performed, e.g because no bat-
tery is connected. Also refer
Signal quality (0..7) or (99) if not measurable. The indicated value is the bit
error rate of the signal received. If there are bit errors this is not a constant but
a estimated value which will change in time. See also
Service availability (0-1)
0: Not registered to any network
1: Registered to home network or, if "roam"=1 then registered to another net-
work
Sounder activity (0-1). The indicator provides information about tones gener-
ated in the ME. Value 1 means for example:
Incoming call - ME is ringing. Note that the URC "
will be output only if ringing tones are activated with
Waiting call - ME generates waiting call tone (if call waiting is enabled).
Outgoing call - ME generates Call Progress tone.
Outgoing call - ME generates BUSY tone.
The value changes to 0 if tone stops
Unread short message at memory location
Call in progress (0-1). Indicator value is "1" if at least one call is in state "active"
or "held".
Depending on the value of
tor "call" will be issued
•
when a state transition ends in state "active" or in state "unknown", if
setting
AT^SCFG
•
when any state transition (including transitions beginning or ending in state
Page 67 of 469
.
AT+CMER
<indDescr>
for control of all indications is recom-
AT^SIND
:
.
AT^SBC
<mem1>
setting (refer parameter
AT^SCFG
="restricted",
<succ>
s
m
obile
.
AT+CSQ
": "sounder" indicator
+CIEV
.
AT^SRTC
(0-1); refer to
AT+CPMS
), indica-
<succ>
2/10/04
Advertisement
Table of Contents
