Storage; Figure 12 - Time Sync. Screen; Figure 13 - Storage Information Screen - Speco LS16 Operation Instruction Manual

Operation Instruction
Figure 12 — Time Sync. screen.
Last Sync-Time displays the last time the DVR was synchronized with the time server.
Highlight Run as Server and press the
the DVR you are setting up will run as a time server.

Storage

Highlight Storage in the System menu and press the
information about the DVR's storage devices.
Figure 13 — Storage Information screen.
NOTE: The DVR does NOT support USB hard disk drives with a version lower than 2.0.
The Information column displays whether the device is being used or not. Other indicates the device has been used
for another DVR.
Highlight the box in the Information column for the desired storage device and press the
16
Highlight the box beside Automatic Sync. and press the
button. This toggles between On and Off.
Highlight the box beside Time Server and press the
A virtual keyboard appears that you can use to enter the IP
address or domain name of the time server. Highlighting
allows you to select your time server from a list of registered
time servers.
NOTE: You can use the domain name instead of IP address
Highlight the box beside Interval and press the
Set the time interval for synchronization from 30 minutes to
1 day at various time intervals.
button. Pressing the
button. The Storage setup screen appears and displays
The information in the Type column describes the storage
device.
The capacity of the storage device is displayed in the Capacity
column.
The Format column displays whether the device is used for
recording (Record) or not (Not Using). Not formatted
indicates the device is not formatted.
device has temporary space set aside so that video clips can
be saved on a DVD RW.
Highlight the box in the Format column for the desired storage device and press the
button. You will be able to format the device for recording. When selecting Not
Using from Use As and highlighting the Format button, the device will not be used
for recording. You can also set aside space to store temporary files for CD or DVD
burning by selecting Partition – CD/DVD Burn.
if you already set up the DNS Server when setting
up the LAN.
button toggles between On and Off. When it is On,
button.
button.
indicates when the
button.