User; Figure 14 - Storage Status Screen; Figure 15 - User Setup Screen - Speco LS16 Operation Instruction Manual

CAUTION: Do NOT disconnect the USB cable or the power from the device while copying video clips.
If the USB cable is disconnected while copying video clips, archived data might be lost.
Highlight the Status tab, and the Storage Status screen displays.
Figure 14 — Storage Status screen.
NOTE: When the storage condition is "Bad", the Event Status – Storage screen displays and you can check
the storage condition for details. Once the "Bad" message displays, replacing the hard disk drive is
recommended, usually within 24 hours.
Temperature and S.M.A.R.T. information will be available only for internal hard disk drives supporting
the SMART (Self-Monitoring Analysis and Reporting Technology) monitoring program.

User

Highlight User in the System menu and press the
and users. You can add and delete groups and users. When adding a group, you can assign authority levels to the group.
Figure 15 — User setup screen.
You will be able to check the model name, serial number and the time
information about recorded data of the selected storage device.
If you want to erase recorded data on the selected device, highlight Clear
and press the button. You will be asked whether or not you want to delete
the data.
If you want to use a USB hard disk drive, highlight Use and press the
button after connecting the device. Highlight Don't Use and press the
button if you want to stop using the device.
The Type column displays the type of storage device.
The Disk Bad column displays the percentage of bad sectors.
Not formatted indicates the device is not formatted.
The Temperature column displays the temperature of the
storage device.
The S.M.A.R.T. column displays "Good", "Bad" or "N/A",
depending on storage conditions.
 Good – The storage condition is normal.
 Bad – Data cannot be written on or read from the storage device.
 N/A – Storage conditions are normal, however, the S.M.A.R.T.
monitoring is not working or supported.
button. The User setup screen displays the authorized groups
The +/- column is used to collapse and expand user groups.
If there is a + or – in this column, it indicates the item is a
Group Name. If there is a – in front of the Group Name, it
indicates that the group has been "expanded" and all of the
User Names within that group are displayed below the Group
Name. If there is a + in front of the Group Name, it indicates
that the group has been "collapsed" and all of the User Names
within that group are hidden. To collapse or expand a group,
highlight the +/- column in front of the desired group and press
the button.
Highlighting a Group Name and pressing the
you to change the authority levels assigned to the group.
Digital Video Recorder
button allows
17