Table of Contents
Advertisement
Operation Instruction
Highlight the Actions tab, and the System Event Actions screen displays.
Figure 45 — System Event Actions screen
NOTE: Alarm-Out action cannot be set to System, Boot Up, Restart, Shutdown and Panic Record events.
Highlight the Notify box beside the desired event (System, Boot Up, Restart, Shutdown, Panic Record, Check
Recording, Check Alarm-In, Disk Almost Full, Disk Full, Disk Bad, Disk Temperature, or Disk S.M.A.R.T.),
and press the
button. You can toggle the entire list On and Off by highlighting Notification and pressing the
button. You can toggle the individual items On and Off by highlighting that item and pressing the
OK and press the
button to accept your changes.
NOTE: For the Notify action to work, the DVR should be registered in the Speco Central (Remote Administration
System).
Event Status
Highlight Event Status in the Event menu and press the
Figure 46 — Event Status screen.
Panic Record will be highlighted while the DVR is in the panic recording mode.
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the level of disk usage reaches
the Disk Almost Full percentage you made in the System Event setup screen on the Event menu. Disk Full will be
highlighted when the DVR is not in the Recycle mode and all available storage space has been used. Disk Config
Change will be highlighted when the DVR reboots after the hard disk drive has been replaced.
Fan Error will be highlighted when the cooling fan to the left of the power cord on the rear panel is not working for
more than four seconds.
Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage section for details.
36
The DVR can be set to react to system events. System events
can be associated with an Alarm-Out connector, sound the
DVR's internal buzzer, and/or notify a number of different
devices.
Highlight the Alarm-Out box beside the desired event (Check
Recording, Check Alarm-In, Disk Almost Full, Disk Full,
Disk Bad, Disk Temperature, or Disk S.M.A.R.T.), and
press the
button. A list of Alarm Outputs appears. You
can associate as many Alarm-Outs with the Event as you wish.
If the DVR detects that event, it triggers output signals on all
the associated Alarm-Out connectors. You can also have the
DVR's internal buzzer sound if an event is detected .
button. The Event Status screen appears.
The Event Status screen displays the status of the DVR's
systems and inputs. Events will be highlighted, and related
channels or events will flicker for five seconds when detected.
( Alarm-In),
(Motion),
and
(Text-In) will be highlighted when each event is
detected based on the settings you made in the Alarm-In,
Motion Detection, Video Loss, Video Blind and Text-In setup
screen on the Event menu.
(Check Alarm-In) and Check Recording will be
highlighted when each event is detected based on the settings
you made in the System Event setup screen on the Event menu.
button. Highlight
(Video Loss),
(Video Blind)
Advertisement
Table of Contents
