Figure 18 - Ez Network Screen - Speco LS16 Operation Instruction Manual

Figure 18 — EZ Network screen.
 Use DSL/PPPoE Setup: Selecting the box allows you to set up the DSL network. Entering the ID and password
for DSL connection is required.
If you selected the Go to EZ Network, select the Next button
to start the EZ Network.
Internet Connection
Select whether or not your DVR is connected to the Internet.
LAN Setup
Select between Auto Configuration and Manual Configuration
for network configuration, and then select the Test button to
test the network configuration you selected.
NOTE: Selecting Auto Configuration allows the DVR to
automatically obtain LAN parameters (IP address,
Gateway, Subnet Mask and DNS Server address).
Selecting Manual Configuration allows you to set
up LAN parameters manually.
NOTE: The network configuration you set should be tested
by selecting Test, otherwise the Next button will
cannot be selected, and you cannot move to the
next step.
DVRNS Setup
 Use DVR Name Service: Select the box to use the DVR
Name Service.
 DVRNS Server: Enter the IP address or domain name of
the DVRNS server.
 Port: Set the port number of the DVRNS server.
 Use NAT: Select the box to use the NAT (Network Address
Translation) device.
 DVR Name: Enter the DVR name to be registered on the
DVRNS server.
 Check: Select the box to check whether or not the name
you entered can be used.
Digital Video Recorder
21