Table of Contents
Advertisement
Operation Instruction
Highlight the LAN tab, and the LAN screen displays.
Figure 49 — LAN (Manual) setup screen.
NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network
administrator.
Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the DNS server.
Highlight Use UPnP and press the
NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug and
Play) service. This function will be especially useful when accessing a port on a private IP address.
NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and
the function should be set to enabled.
You cannot change the port settings when Use UPnP is On.
Highlight the Status box and press the
service.
Highlight the Port Number Setup... box and press the
NOTE: You will need to get the appropriate Port Numbers for each Speco Central and Speco Remote related
program (Admin, Callback, Watch, Search and Audio) from your network administrator.
NOTE: The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running Speco Central or Speco Remote.
CAUTION: When changing the port settings, you must change the port settings on the PC running
Speco Central as well. Refer to the Speco Central Operation Instruction for details.
38
Highlight the box beside Type and press the
can select the type of network configuration from: Manual,
DHCP and ADSL (with PPPoE). Select the desired type
and press the
Selecting Manual from the Type allows you to set up LAN
parameters manually.
Change the numbers by highlighting them and using the Up
and Down arrow buttons to increase or decrease the number.
The factory default LAN settings are:
IP Address:
Gateway:
Subnet Mask:
button to toggle between On and Off. When it is On, port forwarding from the
button to display the port numbers forwarded from the NAT device via UPnP
button. The Port Number Setup screen appears.
Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number. The factory default Port settings are:
Remote Admin:
8200
Remote Callback:
8201
Remote Watch:
8016
Remote Search:
10019
Remote Audio:
8116
button.
192.168.1.129
192.168.1.254
255.255.255.0
button. You
Advertisement
Table of Contents
