Turning On The Power - Kodak XLS 8400 PS User Manual

Getting Started
1–34

Turning on the Power

Press the "|" side of the power switch to turn on the printer. The switch is
located on the lower left side of the printer.
It may take up to one minute for the printer to initialize. During this time,
the power light will illuminate and two messages will display alternately
on the display panel:
INITIALIZING*
INITIALIZING**
PLEASE WAIT
When the printer is ready a set of three messages will flash on the
display panel:
READY
media type
ribbon type
media type will be replaced by the size and type of media that is loaded
in the paper tray. For example, "210X307 mm TRANS".
ribbon type will be replaced by the type of ribbon that is loaded in the
printer. For example, "XTRALIFE COLOR".
If the printer fails to initialize, the following message will appear on the
control panel:
INIT ERROR
If this message appears, turn the printer off and back on again.
NOTE: If the connection type is parallel, make sure that the host
computer is up and running before turning the printer on again.
If the message appears again, the printer requires service.
Part No. 4B1709 March 1995