Table of Contents
Advertisement
Correcting Problems
4–8
Symptom
No printer response when
buttons are pressed.
Display panel says CHANGE
RIBBON, but the correct ribbon
is loaded and the supply spool is
not empty.
Display panel says CHECK
TRAY, but tray is not empty.
Display panel says LOAD
TRANS or LOAD PAPER, but
tray is not empty.
Display panel says LOAD
RIBBON, but ribbon is already
loaded.
Dirt appears on prints.
Possible solution(s)
You may have pressed invalid
buttons.
1. Make sure the printer cover is
closed.
2. Reinsert the paper tray.
3. Restart the printer.
4. Make sure the printer is in
READY mode.
D
Open the printer cover and
check to see if the barcode on
the ribbon is legible.
D
Check to see if the ribbon
is jammed.
D
Open the printer cover, remove
tray, and inspect for paper jam.
The requested media is not
loaded in the printer.
D
Load the requested media.
The requested ribbon is not
loaded in the printer.
D
Open the printer cover and load
the requested ribbon.
D
Make a test print to clean out
remaining debris.
D
Clean the thermal head per the
instructions in Getting Started. If
streaks persist, use the
alternate procedure described
in this chapter.
Part No. 4B1709 March 1995
Advertisement
Table of Contents
