Table of Contents
Advertisement
Part No. 4B1709 March 1995
Symptom
Multicolored spots appear
on prints.
Printer initializes, but does not
enter the READY state.
Edges of transparency material
curl on dense prints.
Paper will not feed.
Correcting Problems
Possible solution(s)
D
Clean the printer and the area
around it.
D
Move printer away from
ventilation ducts or open doors.
D
Disconnect and reconnect the
interface cable to the printer.
D
Restart the printer. If the
problem persists, service
is required.
D
Put prints in transparency
sleeves.
D
Try using the Printer Driver or
Export Module's Mirror option
which will change the way that
the ink is applied to the page.
D
Look at the paper and
remove any sheets from the
stack that have irregularities.
D
Reduce the size of the stack of
media in the paper tray.
D
Make sure that the blue stiffener
sheet is at the bottom of the
paper tray.
4–7
Advertisement
Table of Contents
