Using And Maintaining The Imager; Operator Control Of The Imager; Turning The Imager Power On And Off - Kodak Dryview 5800 User Manual

2
Using and Maintaining the
Imager

Operator Control of the Imager

Turning the Imager Power ON and OFF

2011-09-09
During normal operation, the imager receives and automatically prints
images sent by modalities over a network. Very little operator control is
required. The main responsibilities of the operator are described in the
following section, along with overview information about using the
imager.
There is a power switch located at the back right of the imager:
•
"|" = Power ON
•
"O" = Power OFF
In the event of a power loss, the imager shuts down. Films in process
will not be completed and will remain where they are located in the
imager.
The imager will restart after power is restored. After self-test, the
imager clears any films in process and automatically reprints any films
that were in process when power was interrupted.
2G0733
Power switch
2-1