Lan Gb A Connector; Lan Gb B Connector; Base-T Ethernet Gb Lan A Connector Leds - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

Table 2-6 Rear Panel Connectors and Switches (continued)
Connector/Switch
Console/Remote/UPS
(optional)
10/100 iLO MP LAN
(optional)
1 Graphics cards can include a 15-pin connector, a 18-pin connector, or both. Only one connecting cable is needed for
each monitor.
Some video cards are preinstalled in the system, while others are packaged separately and shipped with the system.
If your system did not ship with a preinstalled graphics card, you must install the card and load the drivers. See the
documentation included with your graphics card.
Frequencies of 85Hz and higher provide flicker-free viewing.
If the monitor you select is DDC-2B or DDC-2B+ compliant, the graphics card automatically limits itself to those
resolutions and frequencies supported by that monitor.
For a complete and current list of supported cards, see: http://partsurfer.hp.com.
For detailed information about individual graphics cards, see the respective manufacturer's website.

LAN Gb A Connector

The rear panel 10/100/1000 base-T Ethernet LAN Gb A connector has the following status and
activity LEDs. See
LEDs.
Figure 2-7 10/100/1000 base-T Ethernet Gb LAN A Connector LEDs
Table 2-7 10/100/1000 base-T Ethernet Gb LAN A Connector LEDs
LED State
1000BT Flashing
100BT Flashing
Activity Flashing

LAN Gb B Connector

The rear panel 10/100/1000 base-T Ethernet LAN Gb B connector has the following status and
activity LEDs. See
LEDs.
Function
25-pin female serial data bus connector for the optional iLO MP. This connector connects
to a three-port breakout cable (HP P/N A6144-63001) with individual connectors for Console,
Remote and UPS. The Console connector becomes the console connection when iLO is
installed.
10/100 Mb LAN connector for the optional iLO MP. Provides LAN console access allowing
Wake-On-LAN, Power-On-LAN, and Alert-On-LAN functions. For details on iLO MP
commands, see the HP Integrity and HP 9000 iLO Operations Guide.
Figure 2-7 and Table 2-7
Color
Amber
Green
Green
Figure 2-8 and Table 2-8
for the location and description of the LAN Gb A
Description
The 1000 MHz with Ethernet protocol and twisted-pair wiring
is enabled, off: no link.
The 100 MHz with Ethernet protocol and twisted-pair wiring
is enabled, off: no link.
LAN activity. With all other LEDs off, activity is 10BT link.
for the location and description of the LAN Gb B
Rear Panel 33