Connections To The Sc-50D/Sc-60D And Dhd Controller; Connecting The Dhd Controller To The Sc-50D/Sc-60D - Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual

Proceed as follows to connect the DHD Controller to the SC-50d/SC-60d, your video
sources, external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Digital Video Connection: Connect the "HDMI Out To Display" connector on the DHD
Controller to the HDMI 1 input in Slot 2 of the SC-50d/SC-60d as shown in Figure 3-9.
Figure 3-9. Connecting the SC-50d/SC-60d to the DHD Controller
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
RJ-11
to DB-9
Adapter
(provided)
Ethernet Ethernet GPIO RS232 IN
HDMI Cable
(not provided)
TRIGGERS
1 2
Y Pb Pr
H V
G B R
Component / SCART
Y Video 1 Video 2
HD1
HD2
Pb Pr Video 3
Y Pb Pr H V
G B R
RS-232
Communication
Cable (provided)
Reset Reset
Wired Keypad Wired Keypad
PWR 1 2
1 - IN 2 - IN 1 - OUT 1 - OUT
Display
Control
Display Control
USB RS-232
IR
3
To Accessory Box
HDMI Out
HDMI 1 HDMI 3
To Display
RS-232
PC / Control
HDMI Out
HDMI 2 HDMI 4 Ethernet
Audio Only
HDMI Out
To Display
29
Installation
3.7
Connections to the
SC-50d/SC-60d and
DHD Controller
Connecting the DHD
Controller to the
SC-50d/SC-60d