Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual page 90

Operation
Input Names
Restore
C o mp o s i t e 1 Composite 1
C o mp o s i t e 2
Composite 2
C o mp o s i t e 3
Composite 3
C o mp o n e n t
Component
H D 1
HD 1
H D 2
HD 2
S C A R T
SCART
H D M I 1 HDMI 1
H D M I 2
HDMI 2
H D M I 3
HDMI 3
H D M I 4
HDMI 4
Input Names: You can give each input a descriptive name. For example, you may want
to change the default input name to the type of source component connected to it:
"VCR," "DVD," "Laptop" et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
Display Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation, perform lens adjustments or access other,
display-device specific functions.
• Installation – Orientation: Select Installation from the Display Device - Configure
menu, then select Orientation to change the picture orientation to suit the method of
installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Lens: Select Lens from the Display Device - Configure menu to access the motorized
lens controls. Refer to Primary Lens Adjustments: Focus, Zoom and Position on
page 42.
• Display Info.: Select Display Info. from the Display Device - Configure menu to see the
projector serial number and lamp usage information (number of hours in service).
• Lamp Hours Reset: When you replace a projector lamp (refer to Lamp
Replacement on page 83), you should also reset its lamp hour counter to zero so that
the lamp usage information in the Display Info. window is accurate. To do this, select
Lamp Hours Reset from the Display Device - Configure menu. Then, select Lamp 1
Hours Reset or Lamp 2 Hours Reset. A confirmation dialog box appears. Select "Yes"
to continue with the reset or "No" to cancel the operation.
• Diagnostics: Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
Network: The options in the Network menu allow you to configure the network
communication features.
• IP Configuration: Select IP Configuration from the Network menu to either set the IP
address, subnet mask and default gateway of the DHD Controller manually or obtain
these settings automatically, from a DHCP (Dynamic Host Configuration Protocol)
server. (Most broadband routers and gateways support DHCP.) You can also test the
network connection from this menu.
or buttons to change a character; press
repeatedly to highlight that input name in the
74 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
or to select