Verify Proper Image Alignment With Anamorphic Lens; Working With The Lamp - Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual

Installation
Verify Proper Image
Alignment with
Anamorphic Lens
3.13
Working With the
Lamp
Focus: Finally, rotate the Focus Ring on the anamorphic
lens to fine-tune the optical focus.
After you have installed the anamorphic lens, ensure that the 2.35:1 image corners and
edges are aligned with the screen with no geometric distortion. Use the Image Alignment
controls to make any necessary adjustments (refer to Adjusting the Image Geometry
on page 43).
At this point you may want to check and adjust the following settings to optimize lamp
performance:
• Adjust the amount of power supplied to the lamp.
• Change the optical aperture size.
To access them, choose Calibration from the Main Menu and enter the Calibration menu
passcode. Then, choose Display Color - Projector Settings -> Lamp (refer to Lamp on
page 69) or Display Color - Projector Settings -> RVR (refer to RVR on page 70).
50 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual