Installing The Primary Projection Lens - Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual

The projection lens is shipped separately from the projector. Proceed as follows to install
it:
1. Remove the lens plug from the lens opening in the projector.
Never operate this projector without a lens. The lens seals the
WARNING
projector, preventing contaminants from entering the interior of the
projector.
2. Remove the rear cap from the lens. (Keep the front lens cap on the projection lens to
protect it from damage during the installation process.)
3. Rotate the lens clamp to the OPEN position.
4. Remove and retain the two security screws from the
lens mount.
5. Align the lens interface plate with the lens mount. Align the lens electrical connector
with the mating connector on the lens mount. Fully insert the assembly straight into
the lens mount opening without turning. Press using your hand.
When installing the lens, ensure that it is not inserted at an angle, as
Note
this can cause damage.
6. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to
lock the lens assembly in place.
7. Re-attach the lens mount security screws that you removed in Step 4.
8. Remove the front lens cap.
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
CLAMP OPEN
CLAMP CLOSED
SECURITY
SCREW
SECURITY
SCREW
MOUNTS
Security
Screws
25
Installation
3.4
Installing the Primary
Projection Lens