Notes On Remote Control Operation; Quick Setup - Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual

Installation
Notes on Remote Control
Operation
3.2

Quick Setup

• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the DHD Controller.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the DHD Controller, and repeat the operation.
Table 3-1 gives a quick overview of the SC-50d/SC-60d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install primary projection lens
2
Install CineWide with AutoScope lens motor (optional)
3
Mount the projector
4
Connect the DHD Controller to the projector
5
Connect signal sources to the DHD Controller
6
Connect other external equipment to DHD Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (AutoScope lens motor,
7
retractable screens or screen masking etc.)
• External IR repeater
• Network hub, router or gateway (Ethernet)
Apply power to the projector
8
Adjust primary lens: projected image size (zoom), position (shift)
9
and focus; copy and paste settings as needed
For rear-screen and/or ceiling-mount installations, select the
10
proper picture orientation
Use Image Alignment controls to fine-tune image geometry
11
Install CineWide anamorphic lens (optional)
12
Adjust CineWide anamorphic lens: position, pitch (angle),
13
geometry and focus
DHD Controller input calibration: adjust the following for each
DHD Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio
14
• Brightness
• Contrast
• Color temperature and white balance
Procedure
• Color level
• Tint
• Input position
16 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
For Details, Refer
to page...
17
25
26, 38
27
29
31
36
40, 41
19, 42
42
43
45
47
53 through 71