Connecting To Ac Power; Ethernet Network Connection To Dhd Controller - Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual

Installation

Connecting to AC Power

Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-20. For more information about configuring and using this
connection, refer to Network on page 74.
RS-232 RS-232
To Accessory Box To Accessory Box
HDMI 3 HDMI 3
HDMI 4 HDMI 4
to Ethernet
Hub, Router
or Gateway
Figure 3-20. Ethernet Network Connection to DHD Controller
Projector and DHD Controller: The SC-50d/SC-60d ships with two (2), AC power
cords: one for the DHD Controller and one for the projector. They are not
interchangeable. The projector power cord is rated at 15 amps and has a ferrite sleeve,
to reduce radio frequency interference (RFI) emissions to a level that conforms to FCC
regulations:
AC power cord
To power outlet
Plug the female end of the projector power cord into the AC receptacle on the rear of the
SC-50d/SC-60d (AC 100V ~ 240V); see Figure 2-2. Then, connect the other end to your
AC power source.
WARNING
Connect the DHD Controller to a nearby AC outlet using the other AC power cord.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
Display Control Display Control
IR IR
HDMI Out HDMI Out
To Display To Display
HDMI Out HDMI Out
Ethernet
Audio Only Audio Only
Ferrite sleeve
Use ONLY the AC power cord with the ferrite sleeve to
connect the projector to AC power. Doing otherwise
creates a fire hazard risk.
40 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -
To Projector AC IN