Connections To The Q-750D Ultra And Dhd Controller; Connector Panel Access; Connecting The Dhd Controller To The Q-750D Ultra - Runco Q-750d Ultra Series Installation & Operation Manual

Proceed as follows to connect the DHD Controller to the Q-750d Ultra, your video
sources, external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
To access the connector panel, pull
firmly on the cable access cover to
open it.
Digital Video Connection: Connect the HDMI Output of the DHD Controller to the DHD
Input of the Q-750d Ultra as shown in Figure 3-10.
Figure 3-10. Connecting the Q-750d Ultra to the DHD Controller
Q-750d Ultra Series Installation/Operation Manual
TRIGGERS TRIGGERS
1 1
Component / SCART Component / SCART
Y Y Video 1 Video 1
HD2 HD2
Pb Pb Pr Pr
Y Y
H H V V
G G
Display
Control
Display Control
IR IR
2 2 3 3
Accessory Box Accessory Box
HDMI Out
To Display
RS-232 RS-232
Video 3 Video 3
HDMI Ou HDMI Ou
HDMI 2 HDMI 2 Ethernet Ethernet
Audio Only Audio Only
HDMI Out
To Display
31
Installation
3.7
Connections to the
Q-750d Ultra and DHD
Controller

Connector Panel Access

Connecting the DHD
Controller to the Q-750d
Ultra