Connections To The Vx-11D And Dhd Controller; Connector Panel Access; Connecting The Dhd Controller To The Vx-11D - Runco VideoXtreme VX-11d Installation & Operation Manual

Proceed as follows to connect the DHD Controller to the VX-11d, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
To access the connector panel, pull firmly
on the cable access cover to open it.
Digital Video Connection: Connect the HDMI Out To Display connector on the DHD
Controller to the DHD Input of the VX-11d as shown in Figure 3-11.
Use an HDMI cable for this connection. A DVI cable with
Caution
DVI-to-HDMI adapters will not work.
Figure 3-11. Connecting the VX-11d to the DHD Controller
Runco VX-11d Installation/Operation Manual
RS-232
RS-232
DHD INPUT
INPUT DHD
Y Y Pb Pb Pr Pr
G G B B R R H H V V
Component / SCART Component / SCART
Y Y
HD2 HD2
Pb Pb
Y Y Pb Pb Pr Pr H H V V
G G B B R R
AC
AC
TRIGGERS TRIGGERS Display Control Display Control
1 1 2 2
Video 1 Video 1 Video 2 Video 2
Pr Pr Video 3 Video 3
HDMI 2 HDMI 2 Ethernet Ethernet
29
3.6
Connections to the
VX-11d and DHD
Controller

Connector Panel Access

Connecting the DHD
Controller to the VX-11d
HDMI Out
To Display
IR IR
HDMI Out
To Display
Installation