Connections To The Ls-100D And Dhd Controller; Connecting The Dhd Controller To The Ls-100D - Runco LightStyle LS-100d Installation & Operation Manual

Proceed as follows to connect the DHD Controller to the LS-100d, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Digital Video Connection: Connect the HDMI Output of the DHD Controller to the DHD
Input of the LS-100d as shown in Figure 3-1.
POWER
RS-232
Figure 3-1. Connecting the LS-100d to the DHD Controller
Lightstyle™ Series LS-100d Installation/Operation Manual
ERROR TEMP
1 1
Component / SCART Component / SCART
Y Y
Pb Pb
TRIGGERS TRIGGERS Display Control
2 2 3 3
HDMI Out
HDMI 1 HDMI 1 To Display
Video 1 Video 1 Video 2 Video 2
Pr Pr
HDMI Ou HDMI Ou
Ethernet Ethernet
Audio Only Audio Only
19
3.5
Connections to the
LS-100d and DHD
Controller
Connecting the DHD
Controller to the LS-100d
Display
Control
IR IR
HDMI Out
To Display
Installation