Connections To The Sc-1 And Dhd Controller; Input Panel Access; Connecting The Dhd Controller To The Sc-1 - Runco Signature Cinema SC-1 Owner's Operating Manual

Installation
3.7
Connections to the
SC-1 and DHD
Controller

Input Panel Access

Connecting the DHD
Controller to the SC-1
Proceed as follows to connect the DHD Controller to the SC-1, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
➤
To access the SC-1 input panel, remove
the two screws holding the input panel
cover in place.
➤
Connect the DVI, RGBHV and RS-232 outputs from the DHD Controller to the
corresponding inputs on the SC-1; see Figure 3-13.
To minimize cable clutter, bundle the
cables together and re-attach the input
panel cover. Pass the cables through the
opening at the bottom of the cover.
Pass cables through
32
Remove these screws
this opening
Replace these screws
Runco SC-1 Owner's Operating Manual