Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual page 88

Operation
• Aspect Ratio - Paste Settings: To apply the lens position, Output Shift and Image
Alignment settings on the clipboard to a different aspect ratio and/or screen, do either
of the following:
• Switch to another aspect ratio (for example, from 16:9 to Cinema).
• Switch from Screen 1 to Screen 2 or vice versa.
Then, select Paste Settings from the Copy/Paste Aspect Ratio menu. The new settings
are saved automatically.
Output Shift: The Left/Right, Up/Down, Width and Height controls in the Output Shift
menu are similar to those in the Input Position menu, except that they change the
characteristics of the output signal. These settings are saved independently for each
aspect ratio and screen selection (refer to Screen on page 56).
• Screen Masking: .This control adjusts the amount of cropping on each edge of the
output image. This differs from the regular Overscan control in two ways:
• It allows separate adjustments on each edge; and
• It is saved per aspect ratio, per screen (as opposed to per connector, per mode).
This is useful for installations where the aspect ratio of the screen doesn't exactly match
the aspect ratio of the display.
Image Alignment: Use the controls in the Image Alignment menu to ensure proper image
geometry; that is, a perfectly rectangular projected image with no keystoning or pincushion.
For detailed instructions, refer to Adjusting the Image Geometry on page 43.
Splash Configure: Use the Splash Configure menu to control the appearance and
behavior of the "splash" screen that appears on the display upon power-up.
• Owner Name/ISF Calibrated/ISF Other: You can have the SC-50d/SC-60d display
the owner's name, your name, the phrase "ISF Calibrated" and/or any other string, up
to 30 characters in length.
Use the up or down cursor button to select a character. Use the right and left cursor
buttons to change the cursor position. Press MENU when you have finished entering
text.
• Splash Timer: When you turn on the SC-50d/SC-60d, it projects a welcome screen
with the Runco and ISF logos, along with the personalized information you enter as
described above. Select Splash Timer from the Splash Configure menu to set the
amount of time for which this screen appears. The range is from 5 to 60 seconds, in
one-second increments. Press
• Splash Enable: When you have finished customizing the splash screen, select Splash
Enable from the Splash Configure menu. Then, select On and press ENTER.
OSD Position: To adjust the position of the OSD, select OSD Position from the
Calibration menu and press ENTER.
Press or to select "Hor." or "Ver." Then, press
or to set the timer, then press MENU.
72 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
or to change the position.