Runco SIGNATURE CINEMA SC-50d Series Installation & Operation Manual page 100

Maintenance and Troubleshooting
5. Install the new lamp:
a Take care to align the new lamp properly in the correct orientation inside the lamp
compartment.
b Press firmly on the lamp to properly seat it.
c Secure the lamp by tightening the three (3) captive screws.
6. Close the lamp compartment cover and tighten the captive screw.
The lamp will automatically turn on again when the cover is closed.
Note
7. Re-attach the Left (Exhaust) Side Panel to the projector.
8. Reset the Lamp Hour Counter: Perform the steps listed in Lamp Hours Reset on
page 74.
84 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual