Quick Setup - Runco LightStyle LS-10d Installation & Operation Manual

Installation
3.2

Quick Setup

Table 3-1 gives a quick overview of the LS-10 installation process. The sections following
this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install anamorphic lens mounting assembly (optional)
2
Mount the projector
3
Connect the DHD Controller to the projector
4
Connect signal sources to the DHD Controller
5
Connect external controller to RS-232 port (optional)
6
Connect 12-volt trigger outputs to anamorphic lens
7
transport and/or other equipment (optional)
Connect projector, DHD Controller and lens motor (if
8
present) to AC power and power up
Primary lens adjustments: projected image size (zoom),
9
position (shift) and focus
For rear-screen and/or ceiling-mount installations, select
10
the proper picture orientation
Install and adjust secondary anamorphic lens (optional)
11
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
12
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
Procedure
18 Runco LS-10d and LS-10HBd Installation/Operation Manual
For Details, Refer to
page...
19
25
30
33
34
38
39
41
22, 42
42
45
49