Installation And Setup; Quick Setup - Runco Video Xtreme VX-40d Owner's Operating Manual

The instructions provided here are for those that are familiar with the projector and wish
to quickly set it up and use it temporarily. Refer to the remaining subsections of this
manual for a more complete setup.
Install the Projection Lens
The projection lens is shipped separately from the projector and must be installed prior to
setting up the projector. Install the projection lens as described in Section 4.5, Replacing
the Projection Lens.
Remove the lens plug from the lens opening in the projector before installing the
lens.
Remove the lens when shipping the projector and reuse the lens plug to prevent
dust and debris from entering and settling on critical optical components.
Position the Projector
Place the projector on a sturdy, level surface and position it so that it is perpendicular to
the screen at a suitable distance. In general, the further back the projector is positioned
from the screen, the larger the image will be.
If required, you can level the projector by adjusting its three feet. With the projector
positioned perpendicular to the screen the image will appear rectangular and not
keystoned.
For more detailed instructions on positioning the projector, refer to Projector Position and
Mounting later in this section.
Connect a Source
Located at the back of the projector is the input panel where all source connections are
made. Each input is clearly labeled for easy identification. Using the appropriate cable(s),
connect your source. Connect RGB and YPbPr sources to INPUT 1 located in the upper
right corner of the input panel. Use the DVI-I connector at INPUT 2 to connect analog
or digital display signals. INPUTS 3 and 4 (Composite and S-Video) are available but
generally not used since these signals would be input to the included DHD Controller.
NOTE: One of the available optional input modules can be installed at INPUT 5 or
INPUT 6 for additional connections.
Refer to Section 2.3, Connecting Sources, for more details on connecting a specific
source.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual

Installation and Setup

3
SECTION 2

2.1 Quick Setup

Step 1
Step 2
Step 3