Installation; Remote Control; Notes On Batteries; Notes On Remote Control Operation - Runco LightStyle LS-10d Installation & Operation Manual

Installation must be performed by a qualified custom video
Note
installation specialist.
To install batteries in the remote control:
1. Press down the tab on the cover and pull the cover in the direction of the arrow.
2. Insert the included batteries. Ensure that the polarities correctly match the
markings inside the battery compartment.
3. Insert the lower tab of the cover into the opening, and press down the cover until it
clicks in place.
• Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the DHD Controller.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the DHD Controller, and repeat the operation.
Runco LS-10d and LS-10HBd Installation/Operation Manual
and
17

3. Installation

3.1

Remote Control

Notes on Batteries

Notes on Remote Control
Operation