Runco LightStyle LS-10d Installation & Operation Manual page 27

4. RS-232 (To Accessory Box)
A male, 9-pin D-sub connector for interfacing with external equipment. (For future
use.)
5. Display Control
Not used with the LS-10.
6. IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
7. POWER INPUT (100 to 240 VAC)
Connect the DHD Controller to power here.
8. HD1 / HD2 (5 x Analog BNCs)
Two inputs (five BNCs per input) for connecting standard-definition (SD = 480i/576i),
enhanced-definition (ED = 480p/576p) or high-definition (HD = 720p/1080i/1080p)
component video sources, or RGBHV sources such as personal computers.
9. Component / SCART (3 x RCA connectors)
SD/HD input for connecting SDTV, EDTV or HDTV component video sources. Also
provides RGB input for SCART RGBS sources.
10. Video 1 / Video 2 / Video 3
Standard, composite video inputs for connecting a VCR, camcorder or other
composite video source. The Video 1 input also provides composite sync input for
SCART RGBS sources.
11. HDMI 1 / HDMI 2 / HDMI 3 / HDMI 4 (Digital)
HDCP-compliant digital video inputs for connecting an HDMI or DVI source.
12. Ethernet
A female RJ-45 connector for wired network communications.
13. HDMI Out (Audio Only)
Connect this output to an audio control system to pass through HDMI audio.
14. HDMI Out (To Display)
Connect this to the DHD Input on the LS-10 (see Figure 2-3).
15. RS-232 (PC / Control)
A female, 9-pin D-sub connector for interfacing with a PC or automation/control
system.
Runco LS-10d and LS-10HBd Installation/Operation Manual 11
Controls and Functions