Runco LightStyle LS-10d Installation & Operation Manual page 86

Operation
• Lamp Hours Reset: When you replace the projector lamp (refer to Lamp
Replacement on page 79), you should also reset the lamp hour counter to zero so
that the lamp usage information in the Display Info. window is accurate. To do this,
select Lamp Hours Reset from the Display Device - Configure menu. A confirmation
dialog box appears. Select "Yes" to continue with the reset or "No" to cancel the
operation.
• Diagnostics: Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
• Altitude: Select Altitude from the Display Device - Configure menu to control the
operation of the projector's cooling fan.
In most cases, the default setting (Auto) will maintain the correct operating
temperature. If the lamp frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change this setting to High.
Network: The options in the Network menu allow you to configure the network
communication features.
• IP Configuration: Select IP Configuration from the Network menu to either set the IP
address, subnet mask and default gateway of the DHD Controller manually or obtain
these settings automatically, from a DHCP (Dynamic Host Configuration Protocol)
server. (Most broadband routers and gateways support DHCP.) You can also test the
network connection from this menu.
• DHCP: To enable the DHCP client in the DHD Controller, select DHCP from the IP
Configuration menu and set it to On. With this setting, the DHD Controller's IP
address, subnet mask and default gateway are assigned by the local DHCP server.
To manually configure these values, set DHCP to Off.
The IP Address, Subnet Mask and Default Gateway items in the IP
Note
Configuration menu are disabled (grayed out) when DHCP is
enabled.
• IP Address: Select IP Address from the IP Configuration menu to manually
configure the IP Address of the DHD Controller, as follows:
1. Press or to select the first, second, third or fourth byte of the address.
2. Press or to set the value of that byte. The range is from 0 to 255 inclusive.
3. Repeat Steps 1 and 2 for all four bytes of the address.
4. Press MENU when you have finished setting the address.
• Subnet Mask: Select Subnet Mask from the IP Configuration menu to manually
configure the IP subnet mask. The procedure is similar to that for setting the IP
address.
• Default Gateway: Select Default Gateway from the IP Configuration menu to
manually configure the default IP gateway. The procedure is similar to that for setting
the IP address.
• Communication Test: Select Communication Test from the IP Configuration menu
to verify proper operation of the network communication link.
70 Runco LS-10d and LS-10HBd Installation/Operation Manual