Runco LightStyle LS-10d Installation & Operation Manual page 83

Copy/Paste - Aspect Ratio: You can also copy and paste certain settings, such as
those for Output Shift, Image Alignment (refer to page 67) or Screen Masking (refer to
page 67) from one aspect ratio or "screen" (refer to Screen on page 52) to another.
To do this, select Copy/Paste from the Calibration menu, then select Aspect Ratio.
• Aspect Ratio - Copy Settings: Select Copy Settings from the Copy/Paste Aspect
Ratio menu to place the Output Shift, Image Alignment and Screen Masking settings
for the current aspect ratio onto a "clipboard," which is a temporary memory location.
When you do, the message "Settings Copied" briefly appears on-screen. The
Copy/Paste menu then re-appears, indicating the source of the copied settings.
Copied settings are not retained after a power cycle.
Note
• Aspect Ratio - Paste Settings: To apply the Output Shift, Image Alignment and
Screen Masking settings on the clipboard to a different aspect ratio and/or screen, do
either of the following:
• Switch to another aspect ratio (for example, from 16:9 to Cinema).
• Switch from Screen 1 to Screen 2 or vice versa.
Then, select Paste Settings from the Copy/Paste Aspect Ratio menu. The new settings
are saved automatically.
Output Shift: The Left/Right, Up/Down, Width and Height controls in the Output Shift
menu are similar to those in the Input Position menu, except that they change the
characteristics of the output signal. These settings are saved independently for each
aspect ratio and screen selection (refer to Screen on page 52).
• Screen Masking: This control adjusts the amount of cropping on each edge of the
output image. This differs from the regular Overscan control in two ways:
• It allows separate adjustments on each edge; and
• It is saved per aspect ratio, per screen (as opposed to per connector, per mode).
This is useful for installations where the aspect ratio of the screen doesn't exactly match
the aspect ratio of the display.
Image Alignment: Use the controls in the Image Alignment menu to ensure proper
image geometry; that is, a perfectly rectangular projected image with no keystoning or
pincushion. For detailed instructions, refer to Adjusting the Image Geometry on
page 43.
Splash Configure: Use the Splash Configure menu to control the appearance and
behavior of the "splash" screen that appears on the display upon power-up.
• Owner Name/ISF Calibrated/ISF Other: You can have the LS-10 display the
owner's name, your name, the phrase "ISF Calibrated" and/or any other string, up to
30 characters in length.
Use the up or down cursor button to select a character. Use the right and left cursor
buttons to change the cursor position. Press MENU when you have finished entering
text.
Runco LS-10d and LS-10HBd Installation/Operation Manual 67
Operation
Copy/Paste
Memory Preset
Aspect Ratio
Aspect Ratio
Copy Settings
Paste Settings
Copied From:
Aspect Ratio 16:9
Screen Screen 1